What Causes Concrete Spalling and How to Fix It

November 10, 2026
Share

Chipped, flaking or broken-away concrete is more than a cosmetic problem. Spalling lets water deeper into the slab, and every Richmond winter gives that water another chance to freeze and widen the damage. Understanding why concrete spalls helps you decide whether a patch, a resurfacing or a full replacement is the right fix.

What Is Concrete Spalling?

Spalling is when pieces of the concrete surface break loose, leaving rough, shallow craters. It is often confused with two other common problems.

  • Spalling means chunks or fragments break away, often around joints, edges or areas where something below the surface is pushing outward.
  • Scaling is thinner flaking or peeling of the top layer across a wider area. The Pennsylvania Aggregates and Concrete Association guide Reducing Concrete Scaling describes it as the flaking or peeling away of the surface.
  • Cracking is a break that runs through the slab rather than peeling off the top.

All three can show up on the same driveway or patio, and they often share the same root causes.

What Causes Concrete to Spall

Spalling rarely has a single cause. Most damage comes from a combination of the following.

  • Freeze-thaw cycles. The American Concrete Institute notes in its technical FAQ that joint deterioration often occurs when saturated concrete freezes and thaws. Water expands as it freezes and pushes the surface apart.
  • Deicing salts. Ice melt draws more water into the surface and can react with the cement paste, which speeds up breakdown around joints and edges.
  • Missing air entrainment. The American Concrete Pavement Association explains that scale-resistant concrete relies on small, closely spaced air bubbles to relieve internal pressure. Concrete without them is far more vulnerable.
  • Finishing and curing mistakes. Working bleed water back into the surface or letting the slab dry out too quickly leaves a weak top layer.
  • Rusting reinforcement. When steel inside the slab corrodes, it expands and pushes the concrete above it outward.
  • Poor drainage. Slabs that stay wet, such as those under downspouts or in low spots, take far more freeze-thaw damage.

Is Spalling a Structural Problem?

Shallow spalling on a driveway, patio or walkway is usually a surface problem, but it should not be ignored. Each spalled area holds water and debris, and the damage tends to grow. Deeper spalls, exposed or rusting steel, or spalling on foundations, steps and retaining walls deserve a professional inspection, because they can point to problems below the surface.

How Spalled Concrete Is Repaired

The right repair depends on how deep the damage goes and how much of the slab is affected. A typical professional spall repair follows the steps outlined in the American Concrete Institute bulletin Spall Repair of Horizontal Concrete Surfaces.

  1. Assess the damage. Sound the surface to find loose or hollow areas beyond what is visible.
  2. Remove unsound concrete. Cut out the damaged material back to solid concrete.
  3. Clean and prepare. Remove dust and debris, and treat any exposed steel.
  4. Place the repair material. Fill the area with a repair product suited to the depth and use of the slab.
  5. Cure properly. Protect the repair so it bonds and gains strength.
  6. Seal the surface. A penetrating sealer helps keep water and salt out of the repaired slab.

When spalling is limited to a few spots, targeted concrete repair in Richmond is often enough. When the surface is worn across a wide area but the slab underneath is still solid and level, concrete resurfacing can restore it with a new top layer. Our guide to when concrete resurfacing makes sense covers how to tell the difference. If the slab is cracked through, sinking or heavily damaged, replacement is usually the better long-term choice.

How to Prevent Spalling

  • Seal exterior concrete with a penetrating sealer before freezing weather
  • Use ice melt sparingly and avoid products containing ammonium nitrate or ammonium sulfate
  • Keep downspouts and grading directing water away from slabs
  • Repair small spalls early before water widens them
  • Choose a contractor who uses air-entrained concrete and proper finishing and curing practices

Frequently Asked Questions

Can spalled concrete be repaired?

Yes. Most spalled driveways, patios and walkways can be repaired by removing the loose concrete and placing a bonded repair material. Widespread or deep damage may call for resurfacing or replacement.

What is the difference between spalling and scaling?

Scaling is thin flaking of the surface across a broad area. Spalling is when larger pieces break away, often at joints, edges or over corroding steel.

Will sealing stop concrete from spalling?

Sealing does not fix existing spalls, but a penetrating sealer reduces how much water and salt enter the surface, which helps prevent new damage.

Is it worth fixing spalling on an old driveway?

If the slab is level and mostly solid, repairing or resurfacing is usually worthwhile. If it is badly cracked or uneven, replacement may give you a better result.

Get Your Spalled Concrete Assessed

Smith Evergreen Concrete repairs, resurfaces and replaces driveways, patios, walkways and steps across Richmond and the surrounding areas. Schedule a free estimate and we will inspect the damage and recommend the right fix.

Contact Smith Evergreen Concrete

Contact Number: (804) 994-8950

Email: info@smith-evergreen.com

Related post

Signs Your Driveway Needs Repair

At Smith-Evergreen Concrete in Richmond, new driveways and repairs are our specialty. We're a top concrete company in Richmond and there's a reason. Driveways are key for safety and beauty at home or work. Signs like cracks, bumps, worn spots, and more mean it's time for a check. Richmond, VA picks us for their concrete […]
Read more

Ways To Cover Concrete Walls In Basements in Richmond

There are multiple ways to cover concrete walls in your basement in Richmond. The benefits of doing so are vast and can really improve your quality of life. Smith Evergreen Concrete in Richmond can give your basement a more modern look instead of a doom and gloom place where you keep space for extra storage. […]
Read more
1 2 3 … 27

What our clients are saying

  • Sam and the team at Smith Evergreen are absolutely awesome. They did a great job, it turned out fantastic. My neighbors already asked for their info. Thank you!
    Mike Clute
  • My sidewalk is finally even, and our steps are nicely spaced!
    Jamie
  • Widening our walkway made our front yard so much more inviting
    Laura
Smith Evergreen Concrete logo with three pine trees above company name
Welcome to Smith Evergreen Concrete, Richmond Virginia's newest concrete contractor. While we may be new to RVA and working throughout Central Virginia, we're not new concrete.  For the last 6 years we've been dedicated to perfecting our trade while working diligently to study the craft of custom stamped concrete in the North West. We are excited to be in Richmond, with family and friends and to have the opportunity to bring our high-quality concrete craftsmanship to the beautiful state of Virginia. 
White Facebook icon on black background Smith Evergreen Concrete social mediaWhite Twitter bird icon on a black background. — Smith-Evergreen Concrete, Richmond VAWhite Instagram icon Smith Evergreen Concrete social mediaA white social media icon for LinkedIn on a black background. — Smith-Evergreen Concrete, Richmond VA

navigation

HomeAbout usService AreasOur Servicesblogcontact

Locations

SMith-Evergreen Concrete Business Office

12631 Oaklake Crest Way, Suite 101, Midlothian, VA 23112

Contact Us

Richmond, virginia
(804) 994-8950
  • This field is for validation purposes and should be left unchanged.
Schedule your free estimate orange call to action button Smith Evergreen Concrete
Proudly part of the Evergreen Richmond family of home services.